Telemetry in/out (common with internal module on non 2019 models), Crossfire control and telemetry PPM/PXX/DSM2/DSMX/SBUS/Serial control signal Still it will work with most standard serial adapters (even USB serial adapters). Taranis serial port uses RS-232 polarity for RX and TX signals, but it won't output full RS-232 voltage levels (from -15V to +15V) on TX line. Only enabled in OpenTX debug builds - debug output Receives telemetry stream on this port, output none
Radios menus HARDWARE screen, Serial port setting: setting
The baud rate depends on what the serial port is set to. OpenTX serial port settings (does not apply to 2019 version)Īll modes use 8 data bits, 1 stop bit, no parity and no flow control. Serial port connector is a JST PH Series connector (it uses 2mm pitch). Taranis serial port pinout (does not apply to 2019 version)Ĭonnect to pin 5 of PC serial port (ground)Ĭonnect to pin 2 of PC serial port (RX line)Ĭonnect to pin 3 of PC serial port (TX line)
